Drilling sandstone tenement interior walls
AK posted on the 11/08/2014 1:12:40 PM
Does anyone have any advice on successfully drilling holes in the interior walls of a Dennistoun sandstone tenement? The walls are full of holes and the plaster/stone crumbles leaving gaping holes not fit for purpose. Planning on filling the holes and re-drilling but wondered if anyone has had any success with this problem.
- 6 Replies :
#6 - anon replied on the 13/04/2022 6:58:40 PM
@CM - Define "heavy things"
#5 - CM replied on the 30/03/2022 5:44:00 PM
anyone had any more success with hanging heavy things in a dennistoun tenement?
#4 - AK replied on the 18/08/2014 6:27:24 PM
Thank you... I'll have a go.
#3 - Abc1 replied on the 13/08/2014 5:32:29 PM
If you're trying to attached something heavy to wall, such as a TV bracket or kitchen unit we've only really found 1 solution...
raggle out the area of the wall large enough for the bracket size and about 10mm deep.
No more nails a peice of 8mm OSB board into the hole, leave to dry.
Plaster over and repaint, leave to dry.
Attached bracket :-)
This process was perfected after numerous shelves, shower rails and a kitchen unit crumbeling off the wall!
#2 - Paul replied on the 12/08/2014 3:33:55 PM
You can get a sandstone drill bit from B&Q should do the trick...
#1 - CuriousCat replied on the 12/08/2014 9:23:06 AM
Use as small a drill bit as you can get away with and hopefully you'll end up with a decent hole for a plug etc.
You can reply to the post Drilling sandstone tenement interior walls by completing the form. No registration required. The forum is moderated in order that messages adhere to the editorial integrity of Dennistoun Online. Please read the guidelines before you submit to the forum. If you believe that we have missed a message that contravenes these guidelines then please contact us and we will either edit or remove it.